Edgestar Dehumidifier Error Codes

Advertisements


Operating the Control Panel continued. The LCD Display will show the room’s relative humidity percentage by default.

Pressing the Increase and Decrease buttons will show the set humidity for a few seconds, and then revert to the room’s relative humidity.

Error Codes 

In addition to showing the humidity, the display may show the following error codes:
AS – Humidity sensor error
Power the unit off, and then unplug the unit for 15 minutes. Plug in and power on. If the issue persists, please contact customer service.
ES – Temperature sensor error
Power the unit off, and then unplug the unit for 15 minutes. Plug in and power on. If the issue persists, please contact customer service.
EC – Unit malfunction
Please make sure whether the ambient temperature is suitable for the stated temperature in the manual or not. If not, please operate the unit under the stated temperature. If the environment temperature is suitable for the stated temperature, please contact customer service.
P2 – Bucket is full
Empty the water bucket and reinstall it.



Advertisements

Advertisements

E1-E2-P1-P2

E1-E2-P1-P2

 

Water Full Light

The Water Full Light will illuminate when the bucket is ready to be emptied. The light also turns on when the bucket is not installed or installed incorrectly. Once the water is drained, and the bucket is properly installed, the unit will operate normally.

Additional notes about the dehumidifier’s behavior:

 *Once the unit reaches the desired set humidity, the power button will remain lit while the compressor and fan shuts off. You will not be able  to change the fan speed.
*If the power to the unit was interrupted while the compressor was running, the unit may take a few minutes to start the fan and  compressor.
* If the room’s relative humidity is lower than the set humidity, the unit  will not start the fan and compressor unless you set the unit to run in Continuous mode.

Model: DEP701EW Manual PDF



Advertisements




Leave a Reply

Your email address will not be published. Required fields are marked *